Here is another shaker card I made.
I used the 'Snowman Magic' Bundle,
along with the Storybook Gnomes DSP.
This is one of the cards that everyone at my Holiday Extravaganza made!
I love the font & these words!
How did I make the shaker?
- Cut a piece of 3 x 4 1/4" Basic White card stock & adhered a piece of 3 x4" Snowflake DSP to it on the top & then a 1x3" ripped piece of White Glimmer paper along the bottom (for the snow).
- Put this into a clear envelope & slide to an edge & bottom.
- Then fold over the edge & use Tear & Tape to make it snug around the other side/corner.
- Put approximately 1/8 tsp of Sparkle & Shine Sequins Assortment into the Clear Envelope & SEAL the end shut.
- Adhere the 3 3/4 x 5" snowflake die cut frame over the top of the shaker envelope piece using Tear & Tape.
- Add Foam Adhesive Strips around the edges & adhere these to the 4 x 5 1/4" piece of Pacific Point card stock.
- Stamp & die cut the snowman & add onto front of card using dimensionals.
Aren't these just SOOO CUTE!
NOTE: The one on the left side is a shaker card.
AND
The one on the right side is the same card without putting it into a clear envelope & adding the sequins.
Here are the supplies & measurements for the shaker card.
stamp set: 'Snowman Magic'
card stock:
- Thick Basic White- 5 1/2 x 8 1/2"- score at 4 1/4" & fold in half for card base
- Pacific Point- 4 x 5 1/4"
- Basic White- 3 3/4 x 5"- die cut snowflake frame
- Basic White- 3 x 4 1/4"
- Basic White- 2" strip- stamp snowman, scarf & hat onto & die cut
- Basic White- 4 x 5 1/4"- for inside of card
- White Glimmer paper- 1 x 3"- rip the very top edge to make look like snow drifts
designer paper: Storybook Gnomes DSP- 3 x 4"
inks: Memento, Real Red, Pacific Point
Stampin' Write Marker: Pumpkin Pie- color nose of snowman
other: Stampin' Cut & Emboss Machine; Snowman Dies; Clear Envelopes; Adhesive Foam Strips; diimensionals; Sparkle & Shine Sequins
I hope you have a WONDERFUL Wednesday!
Happy stamping!
Hugs-
SUSIE
No comments:
Post a Comment